Grace USA Gun Care Screwdriver Sets

GRACE USA Original Gun Care Screwdriver Set.

This 8 piece set was in your grandfather's gun repair box. Hand assembled and custom hollow-ground to fit scope screws, plug screws, guard screws, floor plate screws, sight screws, and many other gun screws as well. The square-shanked blades are hardened and tempered to R/C 52-56 and guaranteed not to twist or chip. The handles are turned from quality Maine hardwood and protected with a smooth finish. Guaranteed to last for years, we will replace screwdrivers from this set that have not met your total satisfaction.
Made in the U.S.A.


 

 


HG-8


GRACE USA Pistolsmith Care Screwdriver Set.

Set of seven Grace USA Gun Care Screwdrivers designed specifically for screws on pistols. Precise for all Colt, S&W, and Ruger handgun screws, plus 90% of all other screws found in pistolsmithing.
Made in the U.S.A.


 

 


HG-7

GRACE USA Browning
Gun Care Screwdriver Set.

Set of five Grace USA Gun Care Screwdrivers specifically made fine Browning screws. Will properly fit tang, mainspring, rear and front trigger plate and carrier screws.
Made in the U.S.A.


 

 


HG-5

GRACE USA Winchester 70
Gun Care Screwdriver Set.

Set of five Grace USA Gun Care Screwdrivers custom made screws found on the Winchester Model 70
Made in the U.S.A.


 

 


HGW-70


SD7 GRACE USA 7 Piece
Mechanic & Home Screwdriver Set.

This set consists of the most commonly needed screwdrivers that are manufactured from the finest materials available. Two Phillips (#1 & #2), Five flat serrated tip blades (1/8" x 4", 3/16" x 3", 3/16" x 5" 1/4" x 5", & 5/16" x 7"). Assembled with Maine hardwood handles.
Made in the U.S.A.

 



SD-7

J3 GRACE USA Scope Driver
Pre-ground, parallel tipped screwdriver correctly fits the windage screw slot to prevent slipping and marring the screw head. Fits windage screws on Leupold®, Redfield®, and Burris® scope bases.
Made in the U.S.A.

SPECS: Steel, blue shank with wooden handle. .24” (6.1mm) blade width x .073” (1.8mm) blade thickness x 6½” (16.5cm) OAL.




J3

 

 


Our Custom Shop will make a screwdriver for any screw not covered by the above mentioned sets.
Send screw or its dimensions and specify the gun and purpose of the screw and we will custom
fit a screwdriver to your needs. Include $10.00 for cost of screwdriver, postage, and handling.


Our Quality Gun Care Tools may be purchased at the following authorized distributors.

Brownells, Gander Mountain, Cabela's,
Dixie Gun Works, Dillion Precision,
Delta Force, Sarco, and
Track of the Wolf

  For additional information please contact us at:
    Voice: (231) 264-8133     FAX: (231) 264-9794
            email: dan@graceusaguntools.com